User Manual E120 Company: Lotus NL B.V. Address: Koningin Julianaplein 10, 1e Verd, 2595AA, The Hague, Netherlands. E-mail: peter@lotusnl.
Important Note Warning And The Guide Of Using Battery Please read the manual to learn the function of the this product before operation. Damage to the product and potential personal injury may occur if you make an operational error. This is a RC helicopter, not a toy. You should not only have a prudent operation, but also to have an operational basis. All children using it should be under adult supervision. Note: Using the original factory USB charger can ensure charging safety.
Helicopter paramenters Introduction of transmitter function Length 235 mm Height 80 mm Weight 95G Propeller Length 256 mm Battery Specification 350mAh Flight Time About 15 min Main Motor 1020 Tail Motor 0720 Charge Time About 60 min Power Indicator One key take off One key landing (Press this button, meanwhile turn on the TX power, to change Mode 1 / Mode 2) Speed Power switch Up, Down, Left, Right Rotation 256 mm Forward，backward， left, right side fly 80 mm Fine-tuning Fine-tuning F
Batteries Charging Method Charging method 1 Installation method of remote controller battery Blue light ladder flashes while charging Fully charged, four lights on Transmitter Charging battery by the USB port on a computer. Description: Push 1. Connect the USB charger with USB port. 2. Connect the battery with USB charger: Blue light ladder flashes while charging Fully charged, Slide the battery lid to open by following the arrow.
Elevator Elevator up forward Corresponding to step 2 Elevator down backward Note: The direction of the battery Card buckle Aileron Forward flight Aileron left Left Aileron right Right Flight Operation Steps 1.Turn on the transmitter and let helicopter stay near to transmitter. 2.Install the aircraft battery in the battery compartment safely and securely. Press the power switch for 2 seconds to turn on the aircraft power. 3.The lights of the helicopter and the remote control flash at the same time.
Commonly used parts replacement instructions Trimming Notes Remove the propeller with a hex wrench, Be careful not to be too tight when installing the new propeller Warning Maintain a flying altitude above one meter Introduction of the corresponding socket of receiver LED LED Main motor The tail motor Optical flow localization Before and after the steering gear Aileron steering gear right Aileron steering gear left Unplug the plug, then twist the motor left and right to pull out First pull out the scre
Abnormal Problem Solving Method Problem Bind the transmitter again Check the power supply of helicopter and transmitter; Check the battery’s voltage of the helicopter and transmitter; Batteries had a poor connecting. Check the installation site of Transmitter’s batteries; Use full voltage batteries; Install the batteries again; Confirm the batteries have a good connecting.
