User Manual E110 Company: Lotus NL B.V. Address: Koningin Julianaplein 10, 1e Verd, 2595AA, The Hague, Netherlands. E-mail: peter@lotusnl.
Important Note Warning And The Guide Of Using Battery Please read the manual to learn the function of the this product before operation. Damage to the product and potential personal injury may occur if you make an operational error. This is a RC helicopter, not a toy. You should not only have a prudent operation, but also to have an operational basis. All children using it should be under adult supervision. Note: Using the original factory USB charger can ensure charging safety.
Helicopter Parameters Introduction of transmitter function Pixel 720P Length 268 mm Height 88 mm Weight 75G Propeller length 249 mm Tail rotor blade diameter 37 mm Battery specification 580 mAh Filght time About 15 min Charge Time About 60 min Power Indicator One key take off One key landing (Press this button, meanwhile turn on the TX power, to change Mode 1 / Mode 2) Speed Power switch Up, Down, Left, Right Rotation Forward，backward， 249 mm left, right side fly 37 mm 80 mm Fine-t
Batteries Charging Method Charging method 1 Charging battery by the USB port on a computer. Installation method of remote controller battery Transmitter Blue light ladder flashes while charging Fully charged, four lights on Description: Push 1. Connect the USB charger with USB port. 2. Connect the battery with USB charger: Blue light ladder flashes while charging Fully charged, Slide the battery lid to open by following the arrow.
Elevator Elevator up forward Elevator down backward Aileron Aileron left Corresponding to step 2 Note:Beginner should pay attention to the direction of flight. Keep the head forward to avoid causing injury. Left Aileron right Forward flight Right Flight Operation Steps Keep a safe distance of more than 2 meters 1.Turn on the transmitter and let helicopter stay near to transmitter. Flight Yaw correction method 2.Install the aircraft battery in the battery compartment safely and securely.
Parts replacement instructions Trimming Notes Use Hexagon wrench to remove the propeller, so that the propeller rotation smoothly, pay attention to a with A, B with B, to ensure that the two propeller balance, installation of the new propeller should not be too tight Warning Maintain a flying altitude above one meter When replacing the tail rod, first disassemble the housing, then remove the tail motor plug, Pull out backwards and pay attention to the direction of installation Introduction of the correspond
Abnormal Problem Solving Method Problem 7 8 Possible Cause Solution Turn on the helicopter power switch, taillight continuously flashing, no response to operation. The helicopter without bind with the transmitter. Bind the transmitter again After turning on the chopper power switch, the chopper Nothing happened. Check the power supply of helicopter and transmitter; Check the battery’s voltage of the helicopter and transmitter; Batteries had a poor connecting.
