User manual

55
Instruction Manual
PSI 8000 3U HS PV Series
EN
Date: 10-28-2011
Using the power supply
6.15.7 Controlling the function manager
The interactive control panel provides keys to control the func-
tion manager. You can halt, continue, reset it to the starting point
or exit the function by using these keys.
Before the function manager is really setting the power supply
you can simulate the function on the display. During this
- the output is not switched on and
- the sequence points are processed step by step and can be
veried this way.
The execution is also controllable via communication with an
interface card. Here you can additionally set one stop point at
one of the 50 sequence points. This sequence point is processed
and the sequence/function is then halted.
The ESC button exits the function manager and
returns to the former state of the power supply.
The STEP button is used to run a sequence stepwi-
se. The current sequence point is excuted after the button was
pressed. After the „step“ has been executed, the set values,
which are displayed in upper right corner of the display, are set.
The RUN button starts the function manager and the
function is run as it was dened. The sequence points are then
processed consecutively.
Example for a simulation during standby:
Use the GO button to continue the function after it
was stopped.
Alternatively, you can reset the function manager to
the start of the current function with the NEW button.