User manual

Irrtümer und Änderungen vorbehalten

About the device

3. Device description

3.1 Front view

Description of the knobs, buttons and terminals:

1) Power output, safety sockets, poled

The sockets can be used to plug 4mm Bueschel plugs or to

clamp spade lugs.

2) Remote sense input, poled

The remote sense leads are connected here with correct

polarity. For details about the remote sense feature refer to

section „Remote sense operation“.

3) Analogue interface, 15pole, D-Sub, female

The socket can be used to remotely control and monitor the

device by means of analogue resp. digital signals. For more

information refer to section „Analogue interface“.

4) Pushbutton „Standby“

Is used to switch the device into standby and back to normal

operation.

5) Rotary encoder, right, no stop

Is used to adjust the set value of the output current.

Approximately 5 complete turns correspond to 0...100%.

In the setup, it is used to adjust settings.

Also see sections „Adjusting set values“ and „Device setup“.

6) Rotary encoder, left, no stop

Is used to adjust the set value for the output voltage and in

preset mode, also to adjust the OVP threshold.

Approximately 5 complete turns correspond to 0...100%.

In the setup, it is used to select parameters.

Also see sections „Adjusting set values“ and „Device setup“.

7) Control panel and display unit

Figure 1