User manual

Page 34
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
EL 3000 B Series
Submenu “Ethernet”
Element Description
Port Default value: 5025
Adjust the socket port here, which belongs to the IP address and serves for TCP/P access
when controlling the device remotely via Ethernet
DNS address Default value: 0.0.0.0
Permanent manual setting of the network address of a domain name server (short: DNS)
which has to be present in order to translate the host name to the device’s IP, so the device
could alternatively access by the host name
Enable TCP
Keep-Alive
Default setting: disabled
Enables/disables the “keep-alive time” functionality of TCP.
Submenu “Communication Protocols”
Element Description
Enabled Default setting: SCPI&ModBus
Enables/disables SCPI or ModBus RTU communication protocols for the device. The
change is immediately effective after submitting it with ENTER button. Only one of both
can be disabled.
Submenu “Communication Timeout”
Element Description
Timeout USB (ms) Default value: 5, Range: 5...65535
USB/RS232communicationtimeoutinmilliseconds.Denesthemax.timebetweentwo
subsequent bytes or blocks of a transferred message. For more information about the timeout
refer to the external programming documentation “Programming ModBus RTU & SCPI”.
Timeout ETH (s) Default value: 5, Range: 5...65535
Denesatimeoutafterwhichthedevicewouldclosethesocketconnectioniftherewas
no command communication between the controlling unit (PC, PLC etc.) and the device
fortheadjustedtime.Thetimeoutisineffectiveaslongasoption“TCPKeep-alive”(see
above) is enabled.
3.4.3.8 Menu “HMI settings”
These settings refer exclusively to the control panel (HMI).
Element Description
Language Selection of the display language between German, English, Russian or Chinese.
Default setting: English
Backlight Setup The choice here is whether the backlight remains permanently on or if it should be switched
off when no input via push buttons or rotary knob is done for 60 s. As soon as input is done,
the backlight returns automatically. Furthermore the backlight intensity can be adjusted here.
Default settings: 100, Always on
Status page Switches to a different main screen layout. The user can select between two layouts which
are depicted by small graphics as a preview. Also see section „3.4.6. Switching the main
screen view“.
Default setting: Layout 1
Key Sound Activates or deactivates sounds when pressing a button on the HMI. It can usefully signal
that the action has been accepted.
Default setting: off
Alarm Sound Activatesordeactivatestheadditionalacousticsignalofanalarmoruserdenedeventwhich
has been set to “Action = ALARM”. See also „3.6 Alarms and monitoring“ on page 42.
Default setting: off
HMI Lock See „3.7 Control panel (HMI) lock“ on page 43.
Default settings: Lock all, No