User manual

Page 33
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
EL 3000 B Series
Setting P. Description
Analog interface Rem-SB 5 This parameter is only displayed if the optional Analog/USB interface is installed.
Selects how the input pin “Rem-SB” of the analog interface shall be working
regarding levels and logic:
• Normal = Levels and function as described in the table in 3.5.4.4
• Inverted = Levels and function will be inverted
Also see „3.5.4.7. Application examples“
3.4.3.3 Menu “Proles”
See „3.8 Loading and saving a user prole“ on page 44.
3.4.3.4 Menu “Overview”
This menu page displays an overview of the set values (U, I, P or U, I, P, R) and alarm settings as well as adjust-
ment limits. These can only be displayed, not changed.
3.4.3.5 Menu “About HW, SW...”
This menu page displays an overview of device relevant data such as serial number, article number etc., as well as
an alarm history which lists the number of device alarms that probably occurred since the device has been powered.
3.4.3.6 Menu “Function Generator”
See „3.9 The function generator“ on page 45.
3.4.3.7 Menu “Communication”
Allsettingsfortheoptional,digitalinterfacewhichcanbeinstalledontherearside,areconguredhere.TheUSB
port,asincludedwithallthreeoptionalinterfacecardsdoesn’trequireconguration.Wheninstallinginterface
typeIF-KE5USBLANthedevicefeaturesanEthernet/LANport.Afterinstallationoracompletedevicereset,that
Ethernet port has following default settings assigned:
• DHCP: off
• IP: 192.168.0.2
• Subnet mask: 255.255.255.0
• Gateway: 192.168.0.1
• Port: 5025
• DNS: 0.0.0.0
• Hostname:“Client”,butcongurableviaPCsoftware
• Domain:“Workgroup”,butcongurableviaPCsoftware
Thosesettingscanbechangedanytimeandconguredtomeetlocalrequirements.Furthermore,thereareglobal
communication settings available regarding timing and protocols.
Submenu “IP Settings 1”
Element Description
Get IP address DHCP: With setting DHCP the device will instantly try to get network parameters (IP, subnet mask,
gateway, DNS) assigned from a DHCP server after power-on or when changing from Manual to
DHCPandsubmittingthechangewithbuttonENTER.IftheDHCPcongurationattemptfails,
the device will use the settings from Manual. In this case, the overview in screen View Settings
will indicate the DCHP status as DHCP (failed), otherwise as DHCP(active)
Manual (default setting): uses either the default network parameters (after reset) or the last user
setting. Those parameters are not overwritten from selection DHCP and are thus available when
switching to Manual again.
IP address Only available with setting “Manual”. Default value: 192.168.0.2
Manual setting of the device’s IP address in standard IP format (setting will be stored)
Subnet mask Only available with setting “Manual”. Default value: 255.255.255.0
Manual setting of the subnet mask in standard IP format (setting will be stored)
Gateway Only available with setting “Manual”. Default value: 192.168.0.1
Manual setting of the gateway address in standard IP format (setting will be stored)