User manual

Page 25
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
EL 3000 B Series
2.3.8.3 Alternative drivers
In case the CDC drivers described above are not available on your system, or for some reason do not function
correctly, commercial suppliers can help. Search the Internet for suppliers using the keywords “cdc driver windows“
or “cdc driver linux“ or “cdc driver macos“.
2.3.9 Connecting the LAN port
AnEthernet/LANinterfaceinformofapluggableinterfacecardisoptionallyavailableandcanberetrottedbythe
user on location into the rear side located slot.
Connection to a remote host of any type (switch, server, PC) is done with standard Cat 5 Ethernet cables (patch
cable, not included with the interface card). There are several parameters to set up proper network connection.
Refer to section 3.4.3 for more information.
2.3.10 Initial commission
Fortherststart-upafterpurchasingandinstallingthedevice,thefollowingprocedureshavetobeexecuted:
• Conrmthattheconnectioncablestobeusedareofasatisfactorycrosssection!
• Check if the factory settings of set values, safety and monitoring functions and communication are suitable for
your intended application of the device and adjust them if required, as described in the manual!
• In case of remote control via PC, read the additional documentation for interfaces and software!
• In case of remote control via the analog interface, read the section in this manual concerning analog interfaces!
During every start the device show a language selection screen for a few seconds where you can quickly switch
the display language. This can also be done later, via the MENU:
2.3.11 Commission after a rmware update or a long period of non use
Incaseofarmwareupdate,returnoftheequipmentfollowingrepairoralocationorcongurationchange,similar
measures should be taken to those of initial start up. Refer to „2.3.10. Initial commission“.
Only after successful checking of the device as listed may it be operated as usual.