User manual

Page 16
ELR/ELM 5000 Series
www.elektroautomatik.de
[e-mail]
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
1.9.3 Scope of delivery
ELR 5000 rack:
1 x 19” 6U rack
1 x Mains cord (IEC plug, Schuko, 16 A) (EU model only)
1 x Set of screws (50 pcs, for xation of load modules or dummy plates)
1 x USB stick with documentation and software
ELM 5000 load module:
1 x Electronic load device
1 x USB stick with documentation and software
1.9.4 Accessories
For these devices the following accessories are available:
Dummy plate
FP ELM
Ordering number: 33220499
Retrottable, easy to install dummy plate for the unoccupied load module slots
of the ELR 5000 rack. For personnel safety and better cooling air stream, it is
imperative to use these dummy plates in case the rack is not fully equipped with
ELM 5000 load modules.
Screws for xing the plates are included.
Network switch
ELM Netgear JGS524
Ordering number: 35410200
24 port Ethernet switch in 1U height, used to connect up to 2 fully equipped ELR
5000 racks to one Ethernet port of a PC, server or another switch. Type: Netgear
JGS524.
The housing of the switch can be recongured to be a 19” rack module with the
included mounting brackets.
Caution!
For reasons of safety it is not allowed to operate the electronic load rack while the front is
not completely closed. In case the rack is not going to be fully equipped with load modules,
a corresponding number of dummy plates must be installed!