User manual

Page 41
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
ELR/ELM 5000 Series
Example CSV:
The example shows that only the rst three se-
quencepointsarecongured,whileallothersare
set to default values.
The view is Excel style, which doesn’t interpret a text
like 00,000 as value, but it doesn’t matter, because
whensavingtheleasCSVallbecomestextagain.
► How to load a sequence le from an USB stick:
1. Do not yet plug the USB stick or remove it, if currently plugged.
2. Access the sequence generator with MENU -> Page 2-> Sequence gen-
erator, to see its main screen, as depicted to the right.
3. Tap touch area , then and follow the instructions on screen.
Ifatleastonevalidlehasbeenrecognizedthedevicewillshowalistof
lestoselectfrom.Forleandpathnaming,aswellaslimitationsregard-
ingthenumberofdisplayableles,seeabove.
Selectalebytappingonthelename.
4. Tap touch area inthebottomrightcorner.Theselectedleisthencheckedandloaded,ifvalid.In
caseitisnotvalid,thedevicewillshowanerrormessage.Thenthelemustbecorrectedandthesteps
repeatedoryoucouldloadadifferentle.
► How to save the currently active sequence to an USB stick:
1. Do not yet plug the USB stick or remove it, if currently plugged.
2. Access the sequence generator with MENU -> Page 2-> Sequence generator.
3. Tap touch area , then .ThedevicewillrequestyoutoplugtheUSBashdrivenow.
4. Afterpluggingit,thedevicewilltrytoaccesstheashdriveandndthefolderHMI_FILESandreadthe
content.Iftherearealreadysequencelespresent,theywillbelistedandyoucaneitherselectonefor
overwriting, otherwise select forthecreationofanewle.
5. Finally save the sequence with .
3.8.4 Remote control of the sequence generator
Thesequencegeneratorcanberemotelycontrolled,butcongurationandcontrolofthesinglefunctions,aswell
as loading sequence point data with individual commands is different from manual operation. The external docu-
mentation “Programming Guide ModBus & SCPI” explains the approach.