User manual

Page 33
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
EL 9000 T Series
3.4.3.3 Menu “Proles”
See „3.9 Loading and saving a user prole“ on page 49.
3.4.3.4 Menu “Overview”
This menu has four submenus which all displays overview information about input set values, limits, events and an
alarm history which lists the number of device alarms that probably occurred since the device has been powered.
Nothing can be changed here.
3.4.3.5 Menu “About HW, SW...”
This menu page displays an overview of device relevant data such as serial number, article number etc.
3.4.3.6 Menu “Function Generator”
See „3.10 The function generator“ on page 50.
3.4.3.7 Menu “Communication”
Heresettingsforthedigitalinterfaceontherearsidearecongured.ThedeviceisdeliveredwithanUSBport
onlywhichdoesn’trequireconguration.ItcanbeextendedbyanEthernet/LANportbyinstallingtheoptional
3-wayinterfaceboardIF-KE3.Afterinstallationoracompletedevicereset,theEthernetporthasfollowingdefault
settings assigned:
• DHCP: off
• IP: 192.168.0.2
• Subnet mask: 255.255.255.0
• Gateway: 192.168.0.1
• Port: 5025
• DNS: 0.0.0.0
• Hostname:empty,butcongurableviaHMI
• Domain:empty,butcongurableviaHMI
Thosesettingscanbechangedanytimeandconguredtomeetlocalrequirements.Furthermore,thereareglobal
communication settings available regarding timing and protocols.
Submenu “Ethernet -> IP Settings 1”
Element Description
Adr. Source DHCP: With setting DHCP the device will instantly try to get network parameters (IP, subnet mask,
gateway, DNS) assigned from a DHCP server after power-on or when changing from Manual to
DHCPandsubmittingthechangewithbuttonENTER.IftheDHCPcongurationattemptfails,
the device will use the settings from Manual. In this case, the overview in screen View settings
will indicate the DCHP status as DHCP (failed), otherwise as DHCP(active)
Manual (default setting): uses either the default network parameters (after reset) or the last user
setting. Those parameters are not overwritten from selection DHCP and are thus available when
switching to Manual again.
IP address Only available with setting “Manual”. Default value: 192.168.0.2
Manual setting of the device’s IP address in standard IP format (setting will be stored)
Subnet mask Only available with setting “Manual”. Default value: 255.255.255.0
Manual setting of the subnet mask in standard IP format (setting will be stored)
Gateway Only available with setting “Manual”. Default value: 192.168.0.1
Manual setting of the gateway address in standard IP format (setting will be stored)
Submenu “Ethernet -> IP Settings 2”
Element Description
DNS address Default value: 0.0.0.0
Permanent manual setting of the network address of a domain name server (short: DNS) which
has to be present in order to translate the host name to the device’s IP, so the device could
alternatively access by the host name
Port Default value: 5025
Adjust the socket port here, which belongs to the IP address and serves for TCP/P access when
controlling the device remotely via Ethernet