User manual
Page 29
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Allemagne
Téléphone : +49 2162 / 3785-0
Fax : +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
EL 9000 T Series
MENU Settings
Overview
Page 1
Page 2
Page 3
Page 5
Enter
Event U
Event I
Event P
UVD = { 0V...Umax }
Aсtion = { NONE | SIGNAL | WARNING |ALARM }
OVD = { 0V...Umax }
Action = { NONE | SIGNAL | WARNING |ALARM }
UCD = { 0A...Imax }
Action = { NONE | SIGNAL | WARNING |ALARM }
OCD = {0A...Imax }
Action = { NONE | SIGNAL | WARNING |ALARM }
OPD = { 0W...Pmax }
Action = { NONE | SIGNA L | WARNING |ALARM }
Page 4
Input Settings U = I = P =
Protection Settings OVP = OCP = OPP =
Limit Settin gs
U-min = U-max = I-min = I-max =
P-max =
General Settings
Reset device
Event Settings
Allow remote control: Yes | No
DC input after power ON: OFF | Restore
Analog interface Rem-SB: Normal | Inverted
Voltage controller setting: Slow | Fast
Enable R mode: Yes | No
DC input after PF alarm: OFF | AUTO
Analog Rem-SB action: DC OFF | DC ON/OFF
Analog interface range: 0...5V | 0...10V
Calibrate device ...
Les paramètres entre parenthèses correspondent à la gamme sélectionnable, ceux soulignés indiquent la valeur par défaut (réinitialisation ou livraison).
Les paramètres dans les blocs en points correspondent aux options et ne peuvent pas être afchés à l’écran.