User manual

Page 26
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
EL 9000 B HP Series
2.3.2 Preparation
Connection to mains of electronic loads of EL 9000 B HP only requires a standard wall socket. The mains cord is
included in the scope of delivery. The devices only consume little power, so there are no further installation or safety
measures required. The loads can also be operated together with different devices on the same distribution box.
2.3.3 Installing the device
• Select the location for the device so that the connection to the source is as short as possible.
• Leavesufcientspacebehindtheequipment,minimum30cm,forventilationofwarmorhot
air that will be exhausted.
A device in a 19” housing will usually be mounted on suitable rails and installed in 19” racks or cabinets. The depth
of the device and its weight must be taken into account. The handles on the front are for sliding in and out of the
cabinet.Slotsonthefrontplateareprovidedforxingthedevice(xingscrewsnotincluded).
Acceptable and unacceptable installation positions:
Standing surface
2.3.3.1 Convert to desktop version
The device is primarily designed for installation in 19” racks and cabinets, but it can also be used as desktop device.
Forthat,the19”xingbracketsontheleftandrightedgeofthefrontplatecouldbedisturbing.Inordertoremove
them and convert the device into a “desktop version”, do following:
1. Unscrew the black handles on the front (hexagon screws) and put them aside.
2. Removethexingbracketsonthesidesbysimplypullingthemout.
3. Inserttheincludedllstrips( ) so the drilling holes match the ones on the front
plate
4. Screw the black handles again.