User manual
Page 39
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
ELR 9000 Series
MENU General Settings
User Events
Profiles
Overview
About HW, SW...
Page 1
Page 2
Allow remote control: Yes | No
DC input after power ON: OFF | RestorePage 3
Analog interface Rem-SB: Normal | Inverted
Voltage controller setting: Slow | Fast
Page 5 Enable R mode: Yes | No
Page 7 Reset device to defaults: Start
Page 8 Master-slave mode: OFF | MASTER | SLAVE
Event U
Event I
Event P
UVD = {0V...Unom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
OVD = {0V...Unom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
UCD = {0A...Inom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
OCD = {0A...Inom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
OPD = {0W...Pnom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
Default Profile
User Profile 1
User Profile 2
User Profile 3
User Profile 4
User Profile 5
Device address: { 1...15 }
Page 4 DC input after PF alarm: OFF | Auto ON
Restart device: Start
Analog Rem-SB action: DC OFF | DC AUTO
PSI / ELR system:
Analog interface range: 0...5V | 0...10V
Calibrate device: StartPage 6
Page 9 Repeat master init.: Initialize
Parameters in curly brackets describe the selectable range, underlined parameters show the default value after delivery or reset.