User manual

26
© 2006, Elektro-Automatik GmbH & Co. KG
Irrtümer und Änderungen vorbehalten
EN
© 2008, Elektro-Automatik GmbH & Co. KG
Index
Page
1. Introduction 27
2.Technicalspecications 27
2.1 Control panel 27
2.2 Devicespecicdata 28
3. Design 29
3.1 Front view 29
3.2 Rear view 29
3.3 Scope of delivery 30
4. General 30
4.1 Prologue / Warning 30
4.2 Mains connection / Grounding 30
4.3 Cooling 30
4.4 Disassembly 30
4.5 Temperature shutdown / Ventilation 30
4.6 Dynamic characterics and stability criteria 30
4.7 Temperature characteristics 30
5. Installation 31
5.1 Visual check 31
5.2 Mains connection 31
5.3 Terminal DC input 31
5.4 Terminal System Bus 31
5.5 Using and connecting the remote sense 31
5.6 Interface card slot 31
6. Handling 32
6.1 The display 32
6.2 Operating elements 33
6.3 Switching power on 34
6.4 Switching the DC input on/off 34
6.5 Adjusting the set values 34
6.6 Preselecting the regulation mode 34
6.7 Usage of Level A and Level B 35
6.7.1 Level A 35
6.7.2 Level B 36
6.7.3 Level A/B (pulsed operation) 36
6.7.4 Rise/fall time 37
6.8 The battery test mode 37
6.9 Alarm management 38
6.10 Control locations and priorities 38
6.11 Series and parallel connection 38
6.12 Functions of the terminal System Bus 39
6.12.1 Two-quadrants operation 39
6.12.2 Selecting the regulation speed 39
6.12.3Crossowadjustment(two-quadrantoperation) 39
6.12.4 Remote sense 39
6.12.5 Pin assignment of terminal System Bus 39
7.Deviceconguration 40
7.1 The setup menu 40
8. The analogue interface 41
8.1 Correct use of the analogue interface 41
8.2 Examplecongurations 41
8.3 Sample applications 42
8.4 Pin assignment of the analogue interface 43
9. Interface cards 44