User manual

53
© 2009, Elektro-Automatik GmbH & Co. KG
EN
Index
Page
1. General 55
1.1 Usage 55
1.2 The concept 55
1.3 Warranty/Repair 55
1.4 Used symbols 55
1.5 Scope of delivery 55
2.Technicalspecications 56
3. Installation 57
3.1 After unpacking 57
3.2 Inserting a card 57
3.3 Combining interface cards 57
4. Details about the cards 57
4.1 RS232 cards IF-R1 and IF-R2 58
4.1.1 ConguringtheRS232card 58
4.2 USB cards IF-U1 and IF-U2 58
4.2.1 ConguringtheUSBcard 58
4.3 CAN cards IF-C1 and IF-U2 58
4.3.1 ConguringtheCANcard 59
4.4 Analogue interface IF-A1 60
4.4.1 Pin assignment of the analogue interface (25-pole D-Sub socket) 60
4.4.2 General 61
4.4.3 ConguringtheIF-A1 61
4.5 GPIB card IF-G1 64
4.5.1 Notes about the communication 64
4.5.2 Controlling a device via GPIB 64
4.5.3 Terms explained 64
4.5.4 Differences to the other interface cards 64
4.5.5 Firmware updates 64
4.5.6 Transmission and execution times 64
4.5.7 ConguringtheIF-G1 64
4.5.8 SCPI commands and Delimiter 65
4.5.9 Errors 74
4.6 Ethernet cards IF-E1 and IF-E2 75
4.6.1 Reset default parameters 75
4.6.2 ConguringtheEthernetcard 75
4.6.3 Communicating with the device 75
4.6.4 The USB port / Firmware updates 76
4.6.5 The reset button 76
5. Operation in other device series 77
5.1 Electronic loads EL 3000 / EL 9000 77
5.2 Series PS 8000 T/ DT / 2U 77
5.3 Series PSI 800 R 77
6. The System Link Mode (only PSI9000) 78
6.1 Handling the System Link Mode 78
6.1.1 Display and handling of the master 78
6.1.2 Display of the slaves 78
6.1.3 Special alarms, warnings and signals 79
6.2 Configuration of the System Link Mode 79