User manual

30
© 2007, Elektro-Automatik GmbH & Co. KG
EN
Index
Page
1. General 31
1.1 Usage 31
1.2 The concept 31
1.3 Warranty/Repair 31
1.4 Used symbols 31
1.5 Scope of delivery 31
2.Technicalspecications 32
3. Installation 33
3.1 After unpacking 33
3.2 Inserting a card 33
3.3 Combining interface cards 33
4. Usage in devices of series PSI 9000 33
4.1 RS232 card IF-R1 34
4.1.1 ConguringtheIF-R1 34
4.2 USB card IF-U1 34
4.2.1 ConguringtheIF-U1 34
4.3 CAN card IF-C1 34
4.3.1 ConguringtheIF-C1 35
4.4 Analogue interface IF-A1 36
4.4.1 Pin assignment of the analogue interface (25-pole D-Sub socket) 36
4.4.2 General 37
4.4.3 ConguringtheIF-A1 37
5. Usage in devices of the series EL3000/EL9000 40
6. The System Link Mode (only PSI9000) 41
6.1 Handling the System Link Mode 41
6.1.1 Display and handling of the master 41
6.1.2 Display of the slaves 41
6.1.3 Special alarms, warnings and signals 42
6.2 Configuration of the System Link Mode 42
7. Communication in detail 43
7.1 Terms explained 43
7.2 Prologue 43
7.3 General notes about the communication 43
7.4 About the USB driver 43
7.5 Structure of the communication 44
7.6 Telegram structure IF-R1 and IF-U1 44
7.6.1 Translating set values and actual values 45
7.7 Message structure for the IF-C1 45
7.7.1 Split messages 45
7.7.2 Timing of messages 45
8. Utilities for the communication 46
8.1 Overview about the Labview VIs 46
8.1.1 Short info Communication VIs 47
8.1.2 Short info Standard VIs 47
9. Guide to program the interface cards 48
9.1 Explanation of the communication object list 48
9.2 Approach 48
9.3 Communication object list 50
9.3.1 For devices of the series PSI9000 50
9.3.2 For devices of the series EL3000A/EL9000A 53
9.4 Error messages of the communication 54
9.5 Alarm codes and alarm categories 54
10. Connectors 55