User manual

45
© 2008, Elektro-Automatik GmbH & Co. KG
EN
Index
Page
1. General 47
1.1 Usage 47
1.2 The concept 47
1.3 Warranty/Repair 47
1.4 Used symbols 47
1.5 Scope of delivery 47
2.Technicalspecications 48
3. Installation 49
3.1 After unpacking 49
3.2 Inserting a card 49
3.3 Combining interface cards 49
4. Usage in devices of series PSI 9000 49
4.1 RS232 card IF-R1 50
4.1.1 ConguringtheIF-R1 50
4.2 USB card IF-U1 50
4.2.1 ConguringtheIF-U1 50
4.3 CAN card IF-C1 50
4.3.1 ConguringtheIF-C1 51
4.4 Analogue interface IF-A1 52
4.4.1 Pin assignment of the analogue interface (25-pole D-Sub socket) 52
4.4.2 General 53
4.4.3 ConguringtheIF-A1 53
4.5 GPIB card IF-G1 56
4.5.1 Notes about the communication 56
4.5.2 Controlling a device via GPIB 56
4.5.2 Terms explained 56
4.5.4 Differences to the other interface cards 56
4.5.5 Transmission and execution times 56
4.5.6 ConguringtheIF-G1 56
4.5.7 Accessory 56
4.5.8 SCPI commands 57
4.5.9 Errors 64
5. Usage in devices of the series EL3000/EL9000 66
6. The System Link Mode (only PSI9000) 67
6.1 Handling the System Link Mode 67
6.1.1 Display and handling of the master 67
6.1.2 Display of the slaves 67
6.1.3 Special alarms, warnings and signals 68
6.2 Configuration of the System Link Mode 68
7. Overview about communication 69
7.1 Terms explained 69
7.2 Prologue 69
7.3 General notes about the communication 69
7.4 About the USB driver 69
7.5 Structure of the communication 70
7.6 Telegram structure IF-R1 and IF-U1 70
7.6.1 Translating set values and actual values 71
7.7 Message structure for the IF-C1 71
7.7.1 Split messages 71
7.7.2 Timing of messages 71
7.8 Message structure IF-G1 72