User manual

About the power supply

3. Device description

3.1 Front view

Description of the knobs, buttons and terminals:

1) Power output, safety sockets, poled

The sockets can be used to plug 4mm Bueschel plugs or

to clamp spade lugs.

2) Remote sense input, poled

The remote sense leads are connected here with correct

polarity. For details about the remote sense feature refer to

section „10.1 Remote sense“.

3) Analogue interface, 15pole, D-Sub, female

The socket can be used to remotely control and monitor

the device by means of analogue resp. digital signals. For

more information refer to section „9. Internal analogue

interface“.

4) Pushbutton „Standby“

Is used to switch the device into standby and back to normal

operation.

5) Rotary encoder, right, no stop

Is used to adjust the set value of the output current, the output

power (models from 1kW) or the internal resistance (optional,

only models with unlocked internal resistance control).

Approximately 5 complete turns correspond to 0...100%.

In the setup, it is used to adjust settings.

Also see sections „6.6 Adjusting set values“ and „7. Device

setup“.

6) Rotary encoder, left, no stop

Is used to adjust the set value for the output voltage.

Approximately 5 complete turns correspond to 0...100%.

In the setup, it is used to select parameters.

Also see sections „6.6 Adjusting set values“ and „7. Device

setup“.

7) Control panel and display unit

Figure 1