User manual

Page 50
PSI 9000 3U Series
www.elektroautomatik.de
[e-mail]
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
3.5 Remote control
3.5.1 General
Remote control is possible via the built-in analog or USB port or via one of the optional interface modules (Any-
Bus CompactCom, only with standard models of PSI 9000 3U series) or via the GPIB port (only with option 3W
installed). Important here is that only the analog or one digital interface can be in control. It means that if, for ex-
ample, an attempt were to be made to switch to remote control via the digital interface whilst analog remote control
is active (Pin Remote = LOW) the device would report an error via the digital interface. In the opposite direction,
a switch-over via Pin Remote would be ignored. In both cases, however, status monitoring and reading of values
are always possible.
3.5.2 Control locations
Control locations are those locations from where the device is controlled. Essentially there are two: at the device
(manual operation) and outside (remote control). The following locations are dened:
Displayed location Description
- If neither of the other locations is displayed then manual control is active and access from
the analog and digital interfaces is allowed. This location is not explicitly displayed
Remote Remote control via any interface is active
Local Remote control is locked, only manual operation is allowed.
Remote control may be allowed or inhibited using the setting “Allow remote control” (see „3.4.3.1. Menu “General
Settings”“). In inhibited condition the status “Local” will be displayed top right. Activating the inhibit can be useful
if the device is remotely controlled by software or some electronic device, but it is required to make adjustments
at the device or deal with emergency, which would not be possible remotely.
Activating condition “Local” causes the following:
• If remote control via the digital interface is active (“Remote”). then remote control is immediately terminated and
must be reactivated at the PC once “Local” is no longer active.
• If remote control is via the analog interface is active (“Remote”) then remote operation is only interrupted until
remote control is allowed again, because pin “Remote” continues to signal “remote control = on”. Exception: if
the level of pin “Remote” is changed to HIGH during the “Local” phase.
3.5.3 Remote control via a digital interface
3.5.3.1 Selecting an interface
The standard models of series PSI 9000 3U support, in addition to the built-in USB port, the following optional ly
available interface modules:
Short ID Art. nr. Type Ports Description*
IF-AB-CANO 35400100
CANopen 1 CANopen slave with generic EDS
IF-AB-RS232 35400101
RS232 1 Standard RS232, serial
IF-AB-PBUS 35400103
Probus 1 Probus DP-V1 slave
IF-AB-ETH1P 35400104
Ethernet 1 Ethernet TCP
IF-AB-PNET1P 35400105
ProNet 1 Pronet DP-V1 slave
IF-AB-DNET 35400106
Devicenet 1 Full Devicenet slave
IF-AB-MBUS 35400107
ModBus TCP 1 ModBus-Protocol via Ethernet
IF-AB-ETH2P 35400108
Ethernet 2 Ethernet TCP, with switch
IF-AB-MBUS2P 35400109
ModBus TCP 2 ModBus-Protocol via Ethernet
IF-AB-PNET2P 35400110
ProNet 2 Pronet DP-V1 slave, with switch
* For technical details of the various modules see the extra documentation “Programming Guide Modbus & SCPI”
Models with option 3W installed offer an additional pre-installed GPIB port next to the default USB port.