Instructions
Page 63
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
PS 9000 3U Series
► How to unlock the HMI
1. Rotate any knob or push any button except ON/OFF.
2. This request pop-up will appear: .
3. Unlock the HMI by pushing within 5 seconds, otherwise the pop-up will disappear and the HMI remains
locked. In case the additional PIN code lock has been activated in the menu “HMI Lock”, another requester
will pop up asking you to enter the PIN before it nally unlocks the HMI.
3.8 Loading and saving a user prole
The menu “Proles” serves to select between a default prole and up to 5 user proles. A prole is a collection of
all settings and set values. Upon delivery, or after a reset, all 6 proles have the same settings and all set values
are 0. If the user changes settings or sets target values then these create a work prole which can be saved to
one of the 5 user proles. These proles or the default one can then be switched. The default prole is read-only.
The purpose of a prole is to load a set of set values, settings limits and monitoring thresholds quickly without
having to readjust these. As all HMI settings are saved in the prole, including language, a prole change can also
be accompanied by a change in HMI language.
On calling up the menu page and selecting a prole the most important settings can be seen, but not changed.
► How to save the current values and settings (work prole ) as a user prole
1. Switch o the DC output and push button to call the
setup menu.
2. In the menu navigate to “Proles” and push .
3. In the sub menu (see gure to the right) select a user prole (1-5) to save to and push again.
4. From the selection on screen chose “Save settings into Prole n” and overwrite that prole with the current
settings and values by conrming with .
► How to load a user prole
1. Switch o the DC output and push button to call the
setup menu.
2. In the menu navigate to “Proles” and push .
3. In the sub menu (see gure to the right) select a user prole (1-5) to load and push again.
4. In the screen you can now select “View Prole n” in order to check the stored settings and to decide, whether
this prole is going to be loaded or not. Navigate to “Load Prole n” and conrm with to nally load
the prole into the work prole.