Instructions

Page 55
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
PS 9000 3U Series
3.4.7 The quick menu
The quick menu o󰀨ers access to some feature which are also accessible from the regular menu, but here they can
be used while the DC output is switched on.
The quick menu is shown when pressing the button and looks like this:
Navigation in the menu is also done with arrow buttons / and .
For example, in this menu it’s possible to preset the output values and to submit with button which allows
for set value steps which would not be possible when rotating a knob. Furthermore, the HMI lock can be activated
here in a shorter way.
3.4.8 Switching the DC output on or o󰀨
The DC output of the device can be manually or remotely switched on and o󰀨. This can be restricted in manual
operation by the control panel being locked.
Switching the DC output on during manual operation or digital remote control can be disabled by
pin REM-SB of the built-in analog interface. For more information refer to 3.4.3.1 and example
a) in 3.5.4.7.
► How to manually switch the DC output on or o󰀨
1. As long as the control panel (HMI) isn’t fully locked press the button ON/OFF. Otherwise you are asked to
disable the HMI lock rst.
2. This button toggles between on and o󰀨, as long as a change isn’t restricted by an alarm or the device is
locked in “remote”. The current condition is displayed with the green LED in button .
► How to remotely switch the DC output on or o󰀨 via the analog interface
1. See section “„3.4.3. Conguration in the setup menu“.
► How to remotely switch the DC output on or o󰀨 via the digital interface
1. See the external documentation “Programming Guide ModBus & SCPI” if you are using custom software,
or refer to the external documentation of LabView VIs or other software provided by the manufacturer.