MSDS

E-6000 WATER BASED SPRAY APPLIED ADHESIVE
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
Put on appropriate personal protective equipment (see section 8). Eating, drinking and
smoking should be prohibited in areas where this material is handled, stored and
processed. Workers should wash hands and face before eating, drinking and smoking.
Handling and storage
Handling
Storage
:
:
7 .
Exposure controls/personal protection
Use a properly fitted, air-purifying or air-fed respirator complying with an approved
standard if a risk assessment indicates this is necessary. Respirator selection must be
based on known or anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before handling
this product.
Personal protection
Eyes
Skin
Respiratory
Consult local authorities for acceptable exposure limits.
:
:
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary.
Hands :
8 .
Engineering measures :
No special ventilation requirements. Good general ventilation should be sufficient to
control worker exposure to airborne contaminants. If this product contains ingredients
with exposure limits, use process enclosures, local exhaust ventilation or other
engineering controls to keep worker exposure below any recommended or statutory
limits.
Hygiene measures :
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period. Appropriate
techniques should be used to remove potentially contaminated clothing. Wash
contaminated clothing before reusing. Ensure that eyewash stations and safety showers
are close to the workstation location.
Recommended monitoring
procedures
:
If this product contains ingredients with exposure limits, personal, workplace atmosphere
or biological monitoring may be required to determine the effectiveness of the ventilation
or other control measures and/or the necessity to use respiratory protective equipment.
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure they
comply with the requirements of environmental protection legislation. In some cases,
fume scrubbers, filters or engineering modifications to the process equipment will be
necessary to reduce emissions to acceptable levels.
>100°C (>212°F)
Liquid.
0.00499109%
1.04
>1 [Air = 1]
Easily soluble in the following materials: water.
Odorless.
White.
Boiling/condensation point
<1 (Water = 1)
Physical and chemical properties
Physical state
Specific gravity
Estimated Vapor Density
VOC %
Evaporation rate
Solubility
Odor
Color
:
:
:
:
:
:
:
:
:
Flash point :
Not available.
9 .
3/6
10/15/2012.