User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 54
24. How do I change the camera IP address to suit my network?
This is performed using the customer software through the USB connection to the camera as
described in the camera documentation and used for downloading pictures.
Note that the camera does not operate with automatically assigned DHCP IP addresses and that
the address selected must not be in use anywhere else on the same subnet for any device.
Therefore, in order to have two cameras connected, at least one IP address must be changed.
If using wireless, remember to consider the control module address as well. If any address is
duplicated, the system will not work. As indicated in FAQ 23 above, a transmitter serial number
20.017 will have the transmitter control module address set to 10.133.220.17.
The Video Capture Battery Pack will only record from a camera with IP address 10.133.1.20
Run the customer software.
Select the ‘Change
Customisable Settings’
option.
Tick the ‘Change Network
Settings’ box.
Enter the desired IP
address.
Click ‘Save to Camera’.