User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 53
23. What IP addresses should be used by the system?
The following IP address allocations are suggested to ensure that all products have a unique
address at all times and will therefore avoid conflicts if coming within range of similar products
owned by others.
P7030 cameras are all set to 10.133.1.20 as delivered from e2v. This ensures that any camera will
appear at the same address to the player, allowing one transmitter to be shared among a number
of cameras. This does present a small risk of conflict.
Transmitter control units are set to 10.133.2xx.xxx, where xx.xxx is the serial number. Serial
numbers run from 20.001 to 20.254, 21.001 to 21.254 and so on.
Receivers sold as systems are set to 10.133.01x.xxx, where x.xxx is the serial number. Serial
numbers run from 0.001 to 0.254, 1.001 to 1.254 and so on.
It is suggested that any other computers used in ad-hoc systems are set to 10.133.0xx.xxx, where
xx.xxx is set to match the transmitter in use.
EPVAs do not have an address requirement, they are purely a connection.
A wired only system is best configured using addresses 10.133.1.xxx for the computer with
10.133.1.1 for the router or using the router default address. The subnet mask in this situation
may be set to 255.255.255.0
It is strongly recommended that cameras used in multiple camera installations are allocated
addresses in the 10.133.1xx.0xx range using their serial numbers. Camera 1234 would be given
address 10.133.112.034 by this method. This ensures unique addresses by design.
Note that this scheme requires a subnet mask set to 255.255.0.0 or wider.
10 133 1 1 Router
10 133 1 2 - 19 Computers in router systems or DHCP range for computers.
10 133 1 20
Camera manufacturer’s default.
Must be used to allow recording with P7030VC
10 133 1 21 - 254 Cameras set up in wired systems.
10 133 10 - 19 1 - 254 Receivers by serial number of receiver.
10 133 20 - 54 1 - 254 User computers set to match transmitters in ad-hoc.
10 133 100 - 199 1 - 99 Cameras reallocated to serial number based IP addresses.
10 133 220 1 Transmitter unit default when reset by magnet.
10 133 220 - 254 2 - 254 Transmitter units by serial number of transmitter.