User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 30
Advanced adjustments should not
normally be needed, but the
following should be noted:
1. These parameters are not
automatically detected in the
transmission and have to be set for
transmitter and receiver, and must
match or the system will not work.
2. Always set for 525 NTSC, this is
the camera output
3. If preferred, set the screen to go
black when no signal is present.
4. The receiver can be set to display
signal strength. This may be of use
in setting up a fixed location such as
a training centre or observation.
The receiver station is supplied with
the two omnidirectional antennae in
the lid connected. The receiver
station may be removed from the
case and the two small rubber
aerials used, in the manner of the
simple receiver unit.
A performance increase may be
obtained if the transmitter is in a
known direction. The central antenna
in the lid is directional, giving
approximately 4 times the signal.
To use this mode, drop the foam
from the lid and disconnect one of
the outer antennas. Reconnect the
lead to the centre connection with
the spanner provided.
There is no need to tighten to an
extreme, over-tightening may cause
damage.