Owner Manual

How to Set Up How to take down
Repeat Step 1 in First Time Top Attachment.
1. Place your E-Z UP
®
frame in the center of
area to be shaded. With
partner on opposite side,
grasp two outer legs,
slightly lift off ground and
step backwards, stopping
at full arms’ length.
1. With partner on opposite side of shelter, stand diagonally fac-
ing one another. Grasp the top and bottom of the diamond shaped
area of trusses on opposite sides. Lift up and step backward until
shelter is 3/4 opened, being careful not to pinch fingers.
3. Lift two adjacent outer legs and slide out inner legs until
the toggle engages the inner leg. Repeat on the opposite legs.
Use spike or weight bags to secure in windy conditions.
2. To engage the Pull - Pin
Auto Slider
®
at each corner,
first lift the fabric off of the
slider, then with one hand hold
the top of the leg while pushing
up on the slider with the other
hand. The pull pin will engage
the hole. Pull down the fabric
valance over the slider. Repeat
on all four corners.
1. With partner, slightly lift up
two adjacent outer legs, release
the toggle and telescope inner
legs into outer legs. Repeat on
the opposite legs.
2. Release pull pin slider
at each corner by first lifting
valance fabric away from slid-
er. With one hand, push up
on truss near slider to remove
the weight of the shelter from
the pull pin. Release slider
by disengaging pull pin and
pushing slider down.
Note: It is much easier to release
pull pin when the shelter weight
has been removed from the
pull pin.
Pull Pin
3. With partner on opposite
sides grasp the top and bot-
tom diamond shaped area over
trusses by “close“ sticker. Lift the
shelter up slightly and shake it
while stepping towards your
partner until the shelter is 3/4
closed. Grasp adjacent outer
legs and push shelter together
until it fully closes.
Be careful not to pinch
fingers.
4. Store shelter in roller bag.
2. Gently unfold the
fabric top and place it
over the open frame.
3. Attach the top to the frame by
matching the quick attachment strips
on the top with the strips on the frame.
Push firmly together at each corner.
*Note: First Time Attachment Is Required.
Top and frame are shipped unattached to avoid damage.
A first time setup requires that top be attached to the frame. Once
top is attached, set up and take down are easily accomplished within
seconds.
• 1 10’ x 10’ (3.0 m x 3.0 m) Pyramid™ Frame
• 1 Recreational Grade Top *
• 4 Piece Standard Spike Kit
• 1 Roller Bag *
* Available in the Shelter Package only
Please read each step before you attempt to set up.
Save these instructions for future reference.