Owner`s manual

OPERATION AND SERVICE INFORMATION
3-33
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Cleaning the Air Filter Element
Do not use compressed air to clean
the air filter. Doing so will damage
the filter and will damage the engine.
If the element is in acceptable condition, loose dirt may be removed by
tapping the filter lightly. Do not use oil on the filter element or any part of
the unit. Install the element in the same way it was removed, being sure
that the clips are fastened securely.
REAR AXLE
The rear axle is provided with a lubricant level check plug located on
the driver side at the rear of the housing (Ref Fig. 35 on page 3-33).
Unless leakage of rear axle lubricant is evident, an annual lubricant
check is sufficient.
Checking the Lubricant Level
Tool List Qty. Required
Socket, 13 mm, 3/8" drive..................................................... 1
Ratchet, 3/8" drive ................................................................ 1
Funnel................................................................................... 1
Clean the area around the check and fill plugs. Remove the check
plug. The correct lubricant level is just below the bottom of the
threaded hole (Ref Fig. 44 on page 3-40). If lubricant is to be added,
remove the fill plug and add lubricant using a funnel. Add lubricant
slowly until lubricant starts to seep from the check plug hole. Install the
check plug and the fill plug. In the event that the lubricant is to be
replaced, a drain plug is provided at the bottom of the differential hous-
ing.
STARTER/GENERATOR BELT TENSION
Tool List Qty. Required
Belt tension gauge................................................................ 1
Wrench, 3/4" ......................................................................... 1
Wrench, 9/16" ....................................................................... 2
Ratchet, 3/8" drive ................................................................ 1
Socket, 3/4", 3/8" drive.......................................................... 1
The starter/generator belt tension should be checked after the first 15 -
20 hours and set to 75 - 80 lbs. (34 - 36 kg).
A loose belt can cause audible vibration and
squeal.
Fig. 35 Add, Check and Drain Rear Axle Lubricant
Check Plug
Drain Plug