Owner`s manual

OPERATION AND SERVICE INFORMATION
3-27
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
TIE RODS/LINKAGES Check for excessive play, bent components or loose connections
REAR AXLE Check for leakage, add SAE 30 oil as required
QUARTERLY - 50 HOURS (includes items listed in previous tables & the following)
FRONT AXLE Check for damage to axle and loose or missing hardware
FRONT SHOCK ABSORBERS Check for oil leakage and loose fasteners
FRONT SPRINGS Check for loose hardware, cracks at attachments
FRONT WHEEL ALIGNMENT Check for unusual tire wear, align if required
PARK BRAKE
Check for bent/binding linkage rod
Check for damage or wear to latch arm or catch bracket
Lubricate as required, use light oil. DO NOT LUBRICATE CABLES OR BRAKE LATCH
REAR SHOCK ABSORBERS Check for oil leakage, loose mounting hardware
ENGINE ELECTRICAL SYSTEM Check coil/spark plug wires for cracks/loose connections
FUEL SYSTEM
Check for leaks at tank, cap, system lines, filters, pump, carburetor
Check system lines for cracks/deterioration
THROTTLE/GOVERNOR LINKAGE Check operation and governed speed
HARDWARE AND FASTENERS
Check for loose or missing hardware and components
Tighten or replace missing hardware
SEMI-ANNUAL - 125 HOURS (includes items listed in previous tables & the following)
BATTERY Clean battery & terminals
DIRECTION SELECTOR Check for wear and smooth movement (lubricate shaft with light oil if required)
KING PINS
Check for excessive play and tightness of retaining nuts
Lubricate, use wheel bearing grease
STEERING ASSEMBLY Lubricate unit and idler arm, use wheel bearing grease
RACK END BALL JOINT Lubricate, use wheel bearing grease
REAR AXLE Check for unusual noise and loose or missing mounting hardware
AIR CLEANER Check filter element, clean/replace as required
OIL FILTER Clean in solvent (at oil change), replace ‘O’ rings if required
ENGINE OIL Replace with SAE 10W-30 or 10W-40 that meets or exceeds SF, SG, CC oil, DO NOT OVERFILL,
DRIVE BELT Check for cracks, fraying and excessive wear
Fig. 24 Periodic Service Schedule