Specifications
Owner’s Guide Page 47
MAINTENANCE PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Lifting the Vehicle
Tool List Qty.
Floor jack................................................................................................................................................................ 1
Jackstands.............................................................................................................................................................. 4
Wheel Chocks ........................................................................................................................................................ 4
Remove payload from vehicle before lifting. No person(s) should be in or on the vehicle while lifting.
To raise the entire vehicle, install chocks in front and behind each front wheel. Center the jack
under the rear frame crossmember. Raise the vehicle enough to place a jack stand under the outer
ends of the rear axle.
Lower the jack and test the stability of the vehicle on the two jack stands.
Place the jack at the center of the front axle. Raise the vehicle enough to place jack stands under
the frame crossmember as indicated.
Lower the jack and test the stability of the vehicle on all four jack stands.
If only the front or rear of the vehicle is to be raised, place the chocks in
front and behind each wheel not being raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
WHEELS AND TIRES
A tire explosion can cause severe injury or death. Nev-
er exceed the inflation pressure rating on the tire side-
wall.
To reduce the possibility of tire explosion, pressurize
tire with small amounts of air applied intermittently to
seat beads. Due to the low volume of the small tires,
overinflation can occur in seconds. Never exceed the
tire manufacturer’s recommendation when seating a
bead. Protect face and eyes from escaping air when
removing a valve core.
To reduce the possibility of severe injury caused by a
broken socket when removing wheels, use only sockets
designed for impact wrench use.
DO NOT use low inflation tires on any E-Z-GO vehicle.
DO NOT use any tire which has a recommended inflation pressure less than the inflation
pressure recommended in the owner’s guide.
Use caution when inflating tires. Overinflation could cause the tire to separate from the
wheel or cause the tire to explode, either of which could cause severe injury.
Tire Repair
Tool List Qty.
Lug wrench, 3/4"..................................................................................................................................................... 1
Impact socket, 3/4" ................................................................................................................................................. 1
Impact wrench ........................................................................................................................................................ 1
Torque wrench, ft. lbs. ............................................................................................................................................ 1
Use caution when inflating tires. Due to the low volume of the small tires, overinflation can occur in seconds. Overinfla-
tion could cause the tire to separate from the wheel or cause the tire to explode.
View from Underside of Vehicle
Lifting The Vehicle
Center of
Front Axle
Flat Portion
of Frame
Outside End
of Rear Axle