Specifications

5 - 7
MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5
Tail/Brake Light
To replace the tail and brake light bulb, insert a small screw-
driver between the rubber bezel and the taillight lens. Roll
the rubber bezel from around the edge of the lens and
remove. Install replacement bulb and replace lens.
FUSE REPLACEMENT
To replace fuses, remove the load bed and remove the con-
troller cover. Locate the fuse block in the electrical box adja-
cent to the controller. Pull out old fuse and replace with a
new automotive type fuse of the correct size.
TRANSPORTING VEHICLE
Towing
This vehicle is NOT designed to be towed.
It is recommended that the vehicle be moved by placing the entire vehicle on a trailer, flat bed truck or other suitable
transport.
Hauling
To reduce the possibility of severe injury or death while transporting the vehicle:
Secure the vehicle and contents.
Never ride on the vehicle being transported.
Always check that the vehicle and contents are adequately secured before transporting. The rated capacity of the
trailer or truck must exceed the weight of the vehicle (see GENERAL SPECIFICATIONS for vehicle weight) and load
plus 1000 lbs. (454 kg). Set the park brake and secure the vehicle using ratchet tie downs.
SERVICE AND MAINTENANCE
To reduce the possibility of severe injury or death from improper servicing techniques:
DO NOT attempt any type of servicing operations before reading all notes, cautions and
FUSE
#
SIZE FOR PART
NUMBER
1
32V
15AMP
Horn / Reverse Warning Indicator 35212G01
2
32V
15AMP
Headlights / Tail Lights 35212G01
3
32V
15AMP
Turn Signals / Brake Lights 35212G01
Rear Body
Tail/Brake
Light
Roll Rubber Bezel Away From
Lens Using Small Screwdriver