Specifications

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5 - 6
5
Wheel Installation
To reduce the possibility of component damage, do not tighten lug nuts to more than 85 ft. lbs. (115 Nm) torque.
It is important to follow the ‘cross sequence’ pattern when installing lug nuts. This will assure even seating of the wheel against
the hub.
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten the lug nuts (1) in a
‘cross sequence’ pattern. Tighten the lug nuts to 50 to 85 ft.
lbs. (68 to 115 Nm) torque in 20 ft. lbs. (27 Nm) increments
following the ‘cross sequence’ pattern.
LIGHT BULB REPLACEMENT
Headlight and Front Turn Signal
For vehicles with headlights (Ref Fig. 10 on page 10),
Remove the two screws on rear of the headlight. Remove
screws, pull headlight out and disconnect wires. Connect
wires to new headlight. Installation is the reverse of disas-
sembles.
To replace the turn signal light bulb, remove connector from
rear of bulb and lens. Unsnap bulb and lens from housing.
Install new bulb and lens by snapping into housing. Install
connector.
NOTICE
Tire/wheel style
may vary
1
2
3
4
'Cross Sequence' 'Cross Sequence'
1
25
34
Headlight Bulb
Turn Signal Bulb
Headlight
Housing
Turn Signal
Housing
Turn Signal
Connector