Specifications

E-Z-GO Division of Textron, Inc., 1451 Marvin Griffin Road, Augusta, Georgia
USA 30906-3852 Phone: [phone], FAX: [phone]
Page 9
6. The starter/generator belt tension should be checked after the first 15 - 20 hours and set to 75 - 80
lbs. (34 - 36 kg).
A loose belt can cause audible vibration and squeal.
E. Spark Plug Replacement
1. Using a 13/16” spark plug wrench, remove the existing spark plugs and replace with the new sup-
plied 5/8” NGK FR2A-D spark plugs (22-NEW). These new spark plugs should be gapped to .035
in. (0.9 mm). Tighten to 18 - 21 ft. lbs. (24 - 28 Nm) torque. See Figure 7.
2. Reconnect the negative battery cable to the battery.
3. Test drive the vehicle and confirm that the factory recommended governed speed is achieved. If the
speed is not within the specified speed range, stop the vehicle and adjust as described in the repair
and service manual.
4. Install the new choke/throttle cover (16-NEW) on top of the existing choke/throttle cover using the
new rivets (17-NEW) and existing washers.
5. Return unit to service.
Fig. 7 Gapping the Spark Plug
.035 in.
(0.9 mm)
Gap
NGK Plug FR2A-D
Bulletin No.
3B-05