Installation & Assembly

Step 8: Assemble the front of your structure. Do not add screws until you have everything adjusted how you would
like them. First add your K boards by sliding in the T brackets and adding the studs. Then build your door assembly.
Attach your door assembly using the hinges you purchased. Attach hinges to the K boards so the doors swing
together like barn doors. There may be a small gap on either side of the door – this is designed so that if you
purchase a non-flush hinge – the door will still open and close. If you do not wish to have a gap, you can cut your
door assembly boards slightly larger for that or adjust the K boards to compensate. Finally measure and cut your E
boards – these might be a slightly different length if you have adjusted the door assembly or K boards at all.
Securely fasten everything with screws once you feel everything is adjusted and in place how you would like it.
Please see the front elevation diagram below.