Installation & Assembly

Step 5: Next assemble your roof trusses. It is typically easier to assemble them on the ground and then put them in
to place on the stud walls. Make sure you use a level for the bottom of the truss (letter B) so they are level or
measure down from the ridge bracket down each truss board. Failure to do this may push the truss out and cause it
not to fit. Layout your roof as shown in the roof plan diagram below.
Step 6: Next you can either add each of the stud wall pieces or assemble them all together on the ground and fit
them in the base at once. Make sure you measure and evenly space all the brackets top and bottom. Next add your
angled corner bracing to make your structure solid and rigid so you can add your trusses. Add your trusses to the top
of each stud. When adding your trusses make sure the 120 degree ridge brackets are all facing the same direction so
you will be able to add your ridge board. Add your ridge and top side wall boards by sliding them through the
brackets and screwing them in to place. Make sure to measure again so all the boards are space evenly. Please see
side elevation diagram below.