User's Manual

Version 1.0.15
164
separately. It’s very troublesome. Please Open Internet browser > Input
192.168.1.1 in the website blank field > Select DHCP Server under the IP Config
Menu. For more information, please refer to 3.3.2 (Router Mode) or 4.3.1 (AP Mode).
4. Q: How do I upgrade the firmware of 11N Mini Broadband Router ?
A: Periodically, a new Flash Code is available for 11N Mini Broadband Router on your
product supplier’s website. Ideally, you should update 11N Mini Broadband Router ’s
Flash Code using Firmware Upgrade on the System Management menu of 11N
Mini Broadband Router Settings.
5. Q: My 11n Mobile Server Router cannot connect to the ISP?
A: There are three possible solutions.
1. Check the Cable/XDSL modem is power on.
2. Check the Cable/XDSL link light is on to verify a good physical connection.
3. Check the WAN port LED to verify if the Cable/XDSL modem is connected to the
router:
If your ISP Login method is following, please make sure the username and password
are correct or not.
If your ISP is using dynamic IP addressing (DHCP) then the DHCP protocol does not
have the authentication feature. Some Cable service providers often use the following
to determine user’s identification.
6. Q: Why is that I can ping to outside hosts, but cannot access Internet websites?
A: Check the DNS server settings on your PC. You should get the DNS servers settings
from your ISP. If your PC is running a DHCP client, remove any DNS IP address
setting. As the router assign the DNS settings to the DHCP-client-enabled PC.
7. Q: 11N Mini Broadband Router couldn’t save the setting after click on Apply
button?
A: 11N Mini Broadband Router will start to run after the setting finished applying, but
the setting isn’t written into memory. Here we suggest if you want to make sure the
setting would be written into memory, please reboot the device via Reboot under
System Management directory.