User's Manual

290
User
’
s Manual V1.0
A: The default WEP of WinXP is Authentication Open System – WEP, but
Server Router only has Pre-Shared Key – WEP. Please change WEP of
WinXP to Pre-shared Key – WEP.
9.7 Supports
1. Q: What is the maximum value for Server Router to support IP
address?
A: Server Router supports 253 IP addresses under NAT mode.
2. Q: Is this Router compatible on different platform?
A: It is compatible to any platform supports Ethernet and TCP/IP.
9.8 Others
1. Q: I always get disconnected on PPPoE mode.
A: Games, music, and antivirus software might send packets to cause the
disconnection. You can close the programs, or you can set the idle time to 0.
2. Q: If there is a DHCP server in local network already, what should I do?
A: Two DHCP servers located on the same network might cause problems. In
this case, please turn off the DHCP server on Server Router and setup your
computer manually.
3. Q: What is purpose for Extend SSID of Server Router on Router and AP
mode?
A: 1. The Router and AP mode use wired connection to link to the Internet. The
SSID can let wireless users search for this router by using site survey function.
The Extend SSID is used to extend the range of other access points. Wireless
Users can connect to the access point by just inputting its SSID.
2. WiFi AP mode uses Wireless to connect to the Internet. The SSID is from
connecting Access Point. The extend SSID can let wireless users search for this
router by using site survey function.
Mode Router AP WiFi AP
WAN
Connect
Wire Wire Wireless
SSID
For User
Connecting
For User
Connecting
From Connecting
Access Point