User's Manual

288
User
’
s Manual V1.0
connect to the Internet, unless it provide a specific name. It is similar to the
network or workgroup name of the function of the region.
When you encounter great difficulties in data transmission, it is better to
keep the situation simple. You can disable all WEP encryption settings.
The successful implementation of the encryption system includes a shared
encryption key. The hex encryption key is commonly used. Encryption keys
will allow the router to confirm workstations as trustable websites. Every
manufacturer can use this encryption key technology. To prevent different
products may not function properly when use on each other. Please be
aware of the detail of encryption key settings.
Make sure that router and network adapter are using the same channel.
You can check to see if the DHCP of your router is enabled or not. The
network adapter will not get an IP address if the DHCP is disabled.
Finally, you may put the system which needs to be configured and the
router on the same space during the initiation. This will reduce the
interference of the wall when the signal is sent.
2. Q: I can’t setup a wireless station on my computer.
A: Check out the following:
 The SSID of your computer and wireless station must be the same. Please
remember the SSID is capital sensitive. E.g. “Workgroup” isn’t the same
with “workgroup”.
 The WEP settings of your computer and wireless station must be the same.
The default for wireless router is disabled, so should your client’s.
 If the WEP of wireless router is enabled, your computer also needs to
activate WP. The key from both sides should match, too.
 It might be interrupted by other radio frequency. Please check the
status when close to the wireless router. Bad communication
environment is like 100 feet of normal situation.
3. Q: The speed of wireless connection is very slow.
A: For the best connecting speed, you can try to: