User's Manual

ETOP 232
User’s Manual V1.0
When users select a specific model on wireless base station, the clients can
connect to the base by selecting the same model.
The connection procedures of PIN and PBC are almost the same. The small
difference between those two is:
Users input the PIN of wireless card in the base station first; it will limit the range
of the clients. It is faster to establish a connection on PIN model.
On PBC model, users push the WPS button to activate the function, and then the
wireless client must push the WPS button in 2 mins to enter the network. The
client will search to see if there is any wireless base station which supports WPS
is activating. If the client finds a matching base, the connection will be
established. The speed of establishing a connection is slower than the PIN model
because of this extra step.
On the other hand, users need to input the information of the wireless card into
the register interface. It might lead to the failure of connection, if users make
mistakes on inputting. On PBC model, users only need to click the WPS button on
both sides to make a connection. It is easier to operate.
This page supports Start PBC and Start PIN; please follow the instructions to
operate.
* Start PBC:
(1.) Please click Start PBC to connect to the wireless network card.