Service manual

SIGNALING SYSTEM
6-11
TROUBLESHOOTING
•Any of the following fail to light : turn
signal light, brake light or an indicator
light.
•The horn fails to sound.
Check:
1. main fuse
3. battery
2. turn signal fuse
4. main switch
5. turn signal switch
6. wiring connections
(of the entire signaling system)
TIP
• Before troubleshooting, remove the follo-
wing part(s):
2.Cap,front
1.Seat
3.Bottom cover,front
• Troubleshoot with the pocket tester.
1. Main fuse
• Check the fuse for continuity.
Refer to “CHECKING THE FUSES” in chap-
ter 4.
• Is the fuse OK?
2. Battery
• Check the condition of the battery.
Refer to “CHECKING AND CHARGING THE
BATTERY” in chapter 5.
Minimum open-circuit voltage
40.0 V or more at 20°C
• Is the battery OK?
3. Main switch
• Check the main switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the main switch OK?
4. Wiring
• Check the entire signal system’s wiring.
Refer to “CIRCUIT DIAGRAM”.
• Is the signaling system’s wiring properly
connected and without defects?
Replace the fuse.
• Recharge or
replace the
battery.
• Clean the battery
terminals.
Replace the main
switch.
Properly connect or
repair the signaling
system’s wiring.
Check the condition
of each of the
signaling system’s
circuits.
Refer to “CHEC-
KING THE SIGNA-
LING SYSTEM”.
YES
NO
YES
NO
YES
NO
YES
NO
–+
ELEC