Service manual

48 V ± 10 V 0 A ~ 30 A
12 V ± 1 V 7 A ± 0.5 A
48 V ± 10 V 25 A ± 1 A
DRIVER
CONT
SPECIFICATION
Power input
Electric
current
Voltage
CHECK AND TROUBLESHOOTING
• If an Avometer displays “
 ”, please replace the
fuse.
Check
Installation
Turn the main switch to “OFF”.
• Install a new fuse of the same specification
and press the fuse to the bottom.
• Close and press the fuse folder cover tightly.
• Turn the main switch to “ON” and confirm each
circuit system can function regularly.
• If the fuse blows out quickly again, please
check each circuit system.
WARNING
• Never use the fuse of a different specification
or other metal to replace the fuse.
• Using the fuse exceeding the specified capacity
will lead to wiring over-heating or blowing out.
1. Connect the pocket tester to the fuse and
check the continuity.
6HWWKHSRFNHWWHVWHUVHOHFWRUWR[
Main fuse
30 A
Turn signal fuse
10 A
• Check the fuse whether blow or not.
Remove
1. Open the upper fuse cover.
DC transfer output
Motor driver output
2. Use a long nose pliers and pull out the fuse.
4-5
TIP