User's Manual

4.16.3 MOTION DETECTION ALERT
This feature is used to enable or disable
o enable M
Detection Low Medium or High M D A
Enable
or
Enable
Disable
This baby monitor uses software based motion detection, in which
monitor compares the change in video displayed on the monitor.
The Low, Medium and High settings determine what level of change
in video should trigger motion detection alert to start video recording.
With “Low” setting a significant change in displayed video will
generate motion detection trigger to start video recording whereas
with “High” setting even a small change in displayed video will
generate motion detection trigger to start video recording.
Motion Detection Alert works the same way
NOTE REGARDING MULTI CAMERA USE
When more than one camera are in use with Auto Scan on and
the monitor is doing manual or motion detection based recording
of active camera e g Camera1 then the monitor will not switch
to another camera unless manual recording is turned off or motion
detection based recording stops
motion alert (beeps)
when ever motion is detected.T motion alert set otion
to , and otion etection lert to
" ".
Menu/OK → Main Menu → Motion Detection
→ Motion Detection → Low,Medium High
&
Menu/OK → Main Menu → Motion Detection
→ Motion Detection Alert→
Once Motion Detection Alert is enabled, the monitor beeps every
time motion is detected.If there is continuous motion,the monitor
beeps continuously.To disable this feature set Motion Detetion
Alert to " ".
.
:
,
( . . ),
.
17