Installation guide

Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
2-10 Basic Setup
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using.
For Windows XP Users Installing a WG511
Install the WG511 driver and configuration
utility software.
a. Power on your notebook, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the WG511
into your CD-ROM drive. The CD index
page shown at the right will load.
c. Click the INSTALL button and an Install
Software window opens. Read the
instructions for running the software
setup utility.
d. Click the Install Software link. When the
browser warning message appears, click
Open to start the Install Shield Wizard.
e. Follow the Install Shield Wizard steps,
and click Finish when done to restart
your computer.
WG511 Resource CD
Note: If this page does not automatically appear,
browse the root of the CD and double-click on
INDEX.HTM to display this page.
Install Shield Wizard
Note: If a Windows XP Certification warning appears,
click Continue Anyway to proceed.