Printer User Manual
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up the Printer
- Chap 2-Using Film and Other Media
- Chap 3-Maintaining and Transporting the Printer
- Chap 4-Solving Problems
- Appendix A: Specifications
- Appendix B: Control Panel Summary
- Index
18
18 | Setting Up the Printer
Unpacking and Assembling the Stand
1. Lift the box up and away from the shipping pallet. Then remove the box
containing the stand and paper basket.
2. Unpack the stand and make sure you have all these items.
3. Insert the strut into the left side as shown. (The sides are labeled
L and
R.)
2 Sides
Manual holder
Horizontal strut
Hex wrench
6 Bolts
2 Wing screws with
lock washers
Note: Make sure you
tighten all bolts before
moving to the next
section.