User`s manual

z J2 : This connector is to connect the audio signal to the sound card.

z J1 : This connector is to connect the power supply for the slim CD-

ROM.

z CON2 : This connector is to connect the IDE interface to the

motherboard.

z JP1 : This jumper is for master/slave select of the slim CD-ROM. For

different brand of the slim CD-ROM, The master /slave selection

method is different, so you have to check with the supplier how to set

the slim CD-ROM to the slave device. Because if you installed the

hard disk with the slim CD-ROM together with the same IDE cable

that you have to set the slim CD-ROM to the slave condition.

Choose your slim CD-ROM vender and set the slim CD-ROM to the slave

condition. Connects all the cables to J1, J2 and CON2 connectors.

Step1. Installing the slim CD-ROM mounting bracket by screw in

the 2 screws, on the HDD/FDD/CD-ROM holding bracket.

Step2. Screw in the 2 M2 screws between the slim CD-ROM

mounting bracket and the converter board.

CON2

J1 JP1