User`s manual

28
Suspend Type
Determines CPU status during power saving mode.
Stop Grant: CPU goes into idle mode during power saving mode.
PwrOn suspend: CPU and system remain powered on in suspend mode.
MODEM Use IRQ
Name the interrupt request (IRQ) line assigned to the modem (if any) on your
system. Activity of the selected IRQ always awakens the system. Default is IRQ3.
Options: N/A,3,4,5,7,9,10,11.
Suspend Mode
Enabled and after the set time of system inactivity , all devices except the CPU will
be shut off.
Options: Disabled,1,2,4,8,12,20,30,40 Min and 1 Hour.
HDD Power Down
When enabled and after the set time of system inactivity,the hard disk drive will be
powered down while all other devices remain active.
Options: Disabled, 1~15 Min.
Soft-off by PWR-BTTN
Use this to select your soft-off function. The default is Instant Off.
Instant Off: Turns off the system instantly.
Delay 4 Second:Turns off the system after a 4 second delay. If momentary press of
button, the system will go into Suspend Mode. Press the power
button again to make system back to work.
CPU THRM-Throttling
This item sets the percentage of time that the CPU is idled if CPU throttling is
initiated by excess heat. The default setting is 50%.
Options:12.5%,25.0%,37.5%,50.0%,62.5%,75.0%,87.5%.
Wake-Up by PCI card
An input signal from PME on the PCI card awakens the system from a soft off
state.
Options: Enabled , Disabled.
Power On by Ring
When enabled , any modem or LAN activity awakens the system from power
savings mode.