User`s manual

24
KB Power ON Password
Press
Hot key power ON
Enables you to set a hot key combination to be used for powering on the system.
The default is Ctrl-F1.
Options: Ctrl-F1~Ctrl F12.
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller(FDC) installed on the
System board and you wish to use it. If you install an and-in FDC or the system has
no floppy drive, select Disabled in this field.
Options: Disabled , Enabled.
Onboard Serial Port 1/2
Select an address and corresponding interrupt for the first and second serial ports.
Options: 3F8/IRQ4,2E8/IRQ3,3E8/IRQ4,2F8/IRQ3,Disabled,Auto.
UART Mode Select
This filed allows the users to configure what IR mode the 2nd serial port should
use.The default is Normal.
Options:Normal,IrDA and ASKIR.
RxD , TxD Active
This field configures the receive and transmit signals generated from the IR port.
The default is Hi Lo (when UART Mode Select is not set to Normal).
Options:Hi Hi,Hi Lo, Lo Hi, and Lo Lo.
IR Transmission Delay
This item allows you to enabled/disabled IR transmission delay.
Options:Enabled , Disabled.