User`s manual

22
UR2 Duplex Mode Half
Use IR Pins IR-Rx2Tx2
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
EPP Mode Select EPP1.7
ECP Mode Use DMA 3
PWRON After PWR-Fail Off
Game Port Address 201
Midi Port Address 330
Midi Port IRQ 10
Onboard Serial Port 3 3E8
Serial Port 3 Use IRQ IRQ10
Onboard Serial Port 4 2E8
Serial Port 4 Use IRQ IRQ11
On-Chip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with support for two
IDE channels. Select Enabled (default) to activate each channel separately.
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4)
for each of the four IDE devices that the onboard IDE interface supports. Modes 0
through 4 provide successively increased performance. In Auto mode, the system
automatically determines the best mode for each device. The default is Auto.
Options : Auto, Mode 0~4.
IDE Primary/Secondary Master/Slave UDMA
This allows you to select the mode of operation for the Ultra DMA-33/66/100
implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party
IDE bus master driver).If your hard drive and your system software both support
Ultra DMA-33/66/100,select Auto to enable UDMA mode by BIOS or you can
select mode by manual.
Options : Auto , Disabled.
USB Controller
Enables the all USB controller.
Options : Disabled , Enabled.
USB 2.0 Controller
Enables the EHCI (USB2.0) controller.
Options : Disabled , Enabled.