User`s manual

2
 CPU and cooling fan with heat sink pre-install on the top of CPU. If you
have ordered the system with CPU together.
 184 pins DDR DIMM memory module from 128MB up to 2GB, if you
have ordered the system with main memory together.
 One set screw pack which including the following:
a. M3 X0.5 screws 12 pcs for FDD/CD-ROM and card installation.
b. M3 X1 screws 4 pcs for HDD installation.
 User’s manual 1 pcs.
 Power cord.
 CD-ROM disk software driver
2. Checking the AC input voltage before turn on the power switch.
The AC input voltage can be switch from 110 Volts to 230 Volts or from
230 Volts to 110 Volts. The AC input voltage convert switch is located on
the back side of the power supply. Please double check whether the AC
input voltage is matching at your country or not. If it is the wrong voltage,
please make the correct setting of this switch.
3. Installing the CPU, if you order the system without CPU installed.
The CPU type is socket 478 and it can be either Intel Celeron speed up to
2.2Ghz or higher and Intel Pentium 4 speed up to 3.06 Ghz or higher
available in the market. Please make sure the correct CPU pin 1 direction
before insert the CPU into the CPU socket. Please also install the CPU
cooling fan on the top of the CPU. Please check the CPU bus speed jumper
setting at JP8 , the manufacturer default setting for JP8 is " Auto " which
means CPU will auto detect the bus speed internally by itself.
4. Installing the memory DDR DIMM module, if you order the system
without memory DDR DIMM module installed.
You can install the 184 pins DDR DIMM memory module into location
DIMM1 and DIMM2 on your motherboard. Since 184 pins DDR DIMM
module is 64 bits wide, therefore 1 piece of DDR DIMM module may
match a 64 bits system , the available memory module from the market will
be from 128 MB up to 1GB , so , the maximum memory size will be up to 2
GB for total 2 DDR DIMMs installed.
5. Installing the hard disk, if necessary.
Please refer to the step 8 of the Mini Desk Top PC system installation at
page No. 8 of this manual for detailed hard disk installation.
6. Installing the floppy disk, if necessary.