User`s manual

15
Virus Warning Disabled ITEM HELP
CPU L1 & L2 Cache Enabled
Quick Power On Self Test Enabled
First Boot Device Floppy
Second Boot Device HDD-0
Third Boot Device LS120
Boot Other Device Enabled
Swap Floppy Drive Disabled
Boot Up Floppy Seek Enabled
Boot Up Numlock Status On
Gate A20 Option Fast
Typematic Rate Setting Disabled
Typematic Rate (chars/Sec) 6
Allows you choose
the VIRUS warning
feature for IDE Hard
Disk boot sector
protection. If this
function is enabled
and someone attempt
to write data into this
area, BIOS will show
a warning message on
screen and alarm beep
Typematic Delay (Msec) 250
Security Option Setup
APIC Mode Enabled
MPS Version Control For OS 1.4
OS Select For DRAM>64MB Non-OS2
Report No FDD For WIN 95 No
Small Logo (EPA) Show Enabled
Virus Warning
During and after system boot up, any attempt to write to the boot sector or partition
table of the hard disk drive halts the system and an error message appears. You
should then run an anti-virus program to locate the virus. Keep in mind that this
feature protects only the boot sector, not the entire hard drive . The default is
Disabled.
Enabled :Activates automatically when the system boots up causing a warning
message to appear when anything attempts to access the boot sector.
Disabled :No warning message appears when anything attempts to access the boot
sector.
Note : Many disk diagnostic programs that access the boot sector table can
trigger the virus warning message. If you plan to run such a program ,
we recommend that you first disable the virus warning.
CPU L1 & L2 Cache
This controls the status of the processor s internal Level One and Level Two cache. The
default is Enabled.
Enabled : This activates the processor s internal cache thereby increasing
performance.
Disabled : This deactivates the processor
s internal cache thereby lowering
performance.