User guide

10
Set Alarms
Adjust
Set Clock
Earl y
Dose
Set Alarms
Adjust
Set Clock
Earl y
Dose
Full Tray Reset
Full Tray Reset
Getting Started
Setting Time, Date, Dispensing Reminder/Alarm Times
Setting the Time and Date
Set the current date and time prior to setting Reminder/Alarms per Day and Dispensing Times, as the
alarm times and sequence refer to the time and date settings. An incorrect time will cause the unit
to alarm and advance to the next dose prior to completing programming.
■ Push the Set Clock
button once: the Hour digits will begin flashing.
■ Adjust the hour (including AM/PM setting) by pushing the - or + buttons.
■ Push the Set Clock button again to accept the setting and advance. Minutes will begin flashing.
■ Follow the same procedure to adjust the Minutes, accept by pushing the Set Clock
button and
advance to Day of the Month.
■ Follow the same procedure to adjust the Day, Month and Year. After Year is set, push the Set Clock
button one last time to accept. All display fields will stop flashing. Date and time are now set.
Note: Day of the Week is automatically set based on the date set at the top of the display.
Note: Each time new batteries are installed in the MedSmart Dispensing Unit, the time will reset to
12:00 PM, however, alarm setting will not be lost.
Setting the Alarm Times, # Per Day and Dispensing Times
Now that the time and date are correct you are ready to set up the alarms, reminders per day and
medication dispensing times. Use this procedure whenever you need to change any setting from a
previous regimen.
Alarm Tones
■ Push the Set Alarms
button once. The alarm tones symbols will begin flashing.
■ Three alarm tones are available: Tone 1
, Tone 2 and Combined Tone 1&2 .
■ Cycle through the Tones by pushing the - or + buttons.
■ Push the Set Alarms button again to accept the setting and advance. # Per Day will begin
flashing.